|
Efficiency of Persulfate Activated by UV Irradiation in the Presence of Granular Activated Carbon for Removal of Methylene Blue Dye from Aqueous Solution
|
Abdolmotaleb Seid-Mohammadi Seid-Mohammadi1    , Hasan Zolghadr Nasab1 , Faezeh Nouri1 , Darya Yavari1 , Fateme Asadi 2 |
1- Department of Environmental Health Engineering, School of Public Health, Hamadan University of Medical Sciences, Hamadan, Iran
2- Student Research Committee, Department of Environmental Health Engineering, School of Public Health, Hamadan University of Medical Sciences, Hamadan, Iran , F_asadi56@yahoo.com |
|
|
Abstract: (1657 Views) |
Background and Aim: Dyes are one of the most important pollutants in textile wastewater (TWW). Use of advanced oxidation processes (AOPs) as an efficient method can be useful for removal of these pollutants from the effluent of textile wastewater. In this study we evaluated the efficiency of the persulfate activation process, using ultraviolet (UV), in the presence of granular activated carbon (GAC) for removal of methylene blue dye (MBD). Also, we studied the effect of operating parameters on dye removal.
Materials and Methods: This experimental study was performed in a pilot-scale batch photoreactor. The effect of operating parameters including solution pH (between 3 and 9), dosage of granular activated carbon (0.6-5 mg/L), persulfate concentration (0.2-2 mmol/L), initial concentration of methylene blue dye (50-400 mg/L), and contact time (2-30 minutes) were evaluated. The final concentration of methylene blue dye was measured by using DR-6000 device. Mineralization of the process, in optimal conditions, was determined by measuring COD and TOC.
Results: The highest efficiency of the process for removal of methylene blue dye (99% dye removal at an initial concentration of 50mg/L) was observed at pH = 3, granular activated carbon dose of 1 g/L, optimal persulfate concentration of 1 mmol/L, and after a 20-minute contact time. The removal rates of COD and TOC were 71% and 69.9%, respectively, and the decomposition rate of methylene blue dye was based on the first-order reaction (R2 = 0.99).
Conclusion: Considering the results of this study, the combined process had a significant efficiency to remove methylene blue dye and can be used as an efficient method for removal of the dye from the effluent of textile wastewater.
|
|
| Keywords: Methylene blue dye, UV wave, Persulfate, Activated Granular Carbon |
|
|
Full-Text [PDF 732 kb]
(733 Downloads)
|
Type of Study: Original Research |
Subject:
Environmental Health Engineering
Received: 2020/01/7 | Accepted: 2020/10/3 | Published: 2021/07/23
|
|
|
|
|
|
|
| Send email to the article author |
|
|
|
| Add your comments about this article |
|
|
|
